SH-M10-1X
Type SH™ Hard Panel Nuts
SH-M10-1X
Type SH™ Hard Panel Nuts
- Installs into thin, harder, high strength steel materials (high strength steel sheets at 975MPA maximum ultimate tensile)
- Allows overall weight reduction for all vehicles
- Provides lower installed cost
- Unplated threads may be oversized sized as permitted by thread standards to accept minimum plating thickness of .00020”/.0051 mm
Compare to other thin sheet fastening devices:– Addresses environmental concerns
- Smaller outer diameter
- Lighter weight
- Flush on reverse side of panel
- Close to edge of panel mounting
- No embossing required
- Hardened nut material provides stronger thread strength
- Can be installed automatically using press or in-die technology
Specifications
- Thread Code
- M10
- Thread Size
- M10 x 1.5
- Thread Specification
- 6H, ASME B1.13M
- Shank Code
- 1
- Fastener Material
- Hardened Alloy Steel
- Standard Finish
- No Finish (with Rust Preventative Oil)
- For Use in Sheet Hardness
- HRC 30 / HB 277 or Less
- Product Category
- Type SH™ Hard Panel Nuts – Metric
- Thread Type
- Internal
- Brand
- PEM
- Hole Size in Sheet +.003 / +0.08mm_mm
- 14mm
- PEM Product Family
- SH
- Product Type
- Nuts
- A Shank Max
- 2.21mm
- E ± 0.25_mm
- 17.35mm
- Hole Size in Sheet + 0.08_mm
- 14mm
- Min. Dist. Hole C/L to Edge_mm
- 13.5mm
- C Max._mm
- 13.97mm
- T ± 0.25_mm
- 7.48mm
Inventory
| Distributor | Quantity | Contact | Phone | Address | Locations |
|---|